Why Eterno Pedestal Paver Help System? If you’re planning to put in elevated exterior paving and rooftop decks on your house or organisation then ‘ETERNO’ Pedestal is the very best paving system for you. It’s the solely screw jack which is quickest, easy and straightforward to put in. Widespread Options: Saves time Guide Slope Adjustors No spacer tabs or shims to put in Put up-installation peak adjustment downside is nil Noise decreasing head Head with inbuilt spacer tabs Shock safety to the pedestal supported pavers Extra Superior Inbuilt Options: Self-levelling head- It has computerized compensation for slopes of as much as 5% Rubber shim on the pedestal head-It’s slip resistance and likewise helps in decreasing noise as much as 25dB Tabs on pedestal- These Pedestal Tabs helps in saving the set up time Adjustment key – It permits micro adjustment of pedestal peak even post- set up course of, there isn’t any have to raise any pavers Fixation machine for wooden unit pavers – It helps to carry the pavers collectively and screwed tightly to the pedestal heads Screw jack development – Helps in peak adjustment Pre-cut strains on pedestal base – It’s for pedestals to be lower rapidly when positioned flush in opposition to a wall Elements of Eterno adjustable peak pedestal: Screw jack pedestal head Swivelling head Self-levelling pedestal head Self-levelling head parts Forms of Eterno Pedestal System: Fastened Top Pedestal Helps The Fastened Top Pedestals are used for increase the paver peak to the extent the place the bottom peak adjustable peak pedestals can be utilized (SE0 at 1.125″). They have inbuilt spacer tabs which can easily be detachable if not required. They are required at the time of installing pavers directly over concrete or other hard surfaces.It prevents the pavers from rocking on the surface which is due to any slight irregularities of the substrate. Features of Fixed Height Pedestal Supports: Low cost solution for installing pavers over concrete Stack supports for heights up to 1.5″ Its Broad is 6″ diam. smooth surface base support Compession load tested to over 12,000 lb Inbuilt spacer tabs snap off for easy removal Resistant to temperatures between -40° to 120°C Slots in base ensure good drainage UV resistant polypropylene SE0 Adjustable Height Pedestals Fully adjustable height range – 1.125″ to 1.5″ Compression load tested to over 4000lb Self-levelling head which automatically adjusts for slopes up to 5% Head slot enables post-installation height adjustment Anti-slip and noise suppressing soft rubber head surface Inbuilt spacer tabs snap off for easy removal Security lock on head coupler prevents rotation beyond safe limit Wide 8″ diam. easy floor base assist Scored strains on base simplify slicing for perimeter set up Proof against temperatures between -40° to 120°C Sturdy polypropylene development Proof against ultraviolet degradation
